The battery level meter gauge showing a full charge on the JBL Charge 5 Speaker. The whole gauge bar is lit in the following picture.
Furthermore, the amount of the meter bar glowing tells you how full the battery is. Normally though, this meter only displays only white light. The flashing red light on the JBL Charge 5 speaker. But this meter should switch to a flashing white light when you connect the speaker to the charger, and the charger to a power outlet, and battery recharging begins. JBL Charge 5 Not Charging, Reasons and FixesĪs we stated earlier, it’s normal that the battery status gauge pulses red when the battery inside is about dead. Then we give possible fixes for this typical problem. So in this post, we offer reasons why the speaker may not charge when connected to power.
#Jbl charge 5 charger how to#
Thus when you notice that the speaker is not recharging, even though it should be, you’ll want to figure out what’s wrong and how to fix the situation.
If you don’t see this happening after two hours of recharging, then chances are, charging is not going well. As the unit recharges, more and more of the meter bar lights up white. But if you sense no warmth, then again, the JBL Charge 5 is probably not charging.įurthermore, the battery gauge normally shows battery recharging status. Note too that the speaker itself warms a bit as well during proper recharging. At that time, it should be slightly warm to the touch. You can also feel the adapter’s side panel ten or fifteen minutes into the charge cycle. But if it keeps blinking red, then correct recharging is likely not happening. When the light changes to white, that means that the speaker is getting some power from the adapter. But the gauge should change at this point though, to blinking white, when you apply charging power. And this flashing keeps going, even when you attach the charger. Now this meter starts pulsing red near its bottom during play, to alert you that the battery is running low on power. How to Tell that the JBL Charge 5 is Not ChargingĪmong the ways you can tell that the Charge 5 is not charging, is by reading the battery status gauge on the front of the speaker. Sometimes though, you may notice that the JBL Charge 5 is not charging fully, or at all, even when you connect the adapter to power, and then to the speaker. And when that battery dies, you can recharge the speaker via an AC or car adapter. Most JBL Bluetooth speakers, including the Charge 5, offer truly wireless operation via the lithium ion battery they have inside.
0 kommentar(er)
